36mm, Rear Axle Nut Wrench Tool. Use on Touring 2003up.
$109.00Suggested additional Purchase JM-970
Showing 49–64 of 171 results
Suggested additional Purchase JM-970
* Used to lock primary for service work* Fits between the chain and motor sprocket* Works on all primaries* Made out of black Delrin®* Made in the U.S.A.
* Locks primary for service work* Made in the U.S.A.
* Locks primary for service workTech Tips:-* Will Not Fit Touring Models.* Made in the U.S.A.
Features & Benefits:-* Fits all H-D Models.* Supplied with six bands.* Works with piston sizes from 2-7/8in. to 4-3/8in..* Fine-tooth ratcheting motion will compress the bands in small increments for accurate compression.* Will Not Break or Damage Rings.Proudly Made in the USA by JIMS !
Features & Benefits:-The Kraus Cartridge Seal Head Driver Tool tool is necessary for Ohlins fork rebuilding and cartridge installation for Ohlins FKS 508 cartridges. This tool uses a 3/8in. drive end and provides easier assembly and disassembly when servicing specific Ohlins forks. Designed and engineered to be used with the KRT Forks (FF52X), Dynamoto Forks…
Features & Benefits:-The Kraus Cartridge Pull Rod Tool will help in installation of specific Ohlins cartridges and forks. This tool comes with M8x1.25, M10x1.25, and M12x1.25 thread sizes allowing it to be used in other applications as well. Designed and engineered to be used with Kraus KRT Forks (FF52X), Dynamoto Forks (FGRT 205s), Ohlins FKS…
Features & Benefits:-Kraus’s Ohlins Cartridge Wrench will help aid you in the installation of your recently purchased Ohlin’s Cartridges. The wrench includes the following tools seldomly found in a toolbox but necessary to install Ohlin’s Cartridges.* 50mm 8 sided closed end used for installing caps* 41mm 6 sided closed end used for installing caps* 13mm…
A tool that every engine builder needs. This tool properly tests the pressure rating of each piston oiler jet before you final assemble your engines.
* Use to lock pinion gear when torquing the pinion gear nut* Simple to use; just align underneath gear and screw into case* With Big Twin tool, use PART #DS-196147 to tighten pinion nut* Made in the U.S.A.
Bolts to case and locks pinion gear, necessary to torque the pinion nut. Use on Big Twin 1954-1999 single-cam engines.
* This tool can be a case saver if you have worn out or damaged tappet bores on any Twin Cam engine case* This is a top quality reamer designed to ream the case creating a perfect oversize hole to fit a +.010 oversize lifter
Showing 49–64 of 171 results
1 × $2,814.00
Subtotal: $13,256.00