MX-1900 2-Position Pin Housing – Black.
$4.00Features & Benefits:-* Replaces OEM # 72905-11Suggested Additonal Purchase = NMZ-NJ-19P (MaleTerminal Pins)
Showing 49–64 of 123 results
Features & Benefits:-* Replaces OEM # 72905-11Suggested Additonal Purchase = NMZ-NJ-19P (MaleTerminal Pins)
* For carburetted bikes only.Pre-assembled ignition harness that provides all sensor wires used with late 2000-03 in.2-plugin. OEM & aftermarket modules. Includes wires for M.A.P. sensor, Crank sensor, bank angle sensor and Ignition Coil,service engine light, Tachometer & Data link.* DTT-1008 Ignition module can be run without the bank angle sensor and without a cam…
Features & Benefits:-* Hose Clamps will fit over most rubber or braided hoses.* Sold as a Pack (6).
Features & Benefits:-* Hose Clamps will fit over most rubber or braided hoses.* Sold as a Pack (6).
Features & Benefits:-* Hose Clamps will fit over most rubber or braided hoses.* Sold as a Pack (6).
* 18in. long* 100% Plug-n-Play* Kit comes with OEM terminals and connectors pre-installed* Easy to install* All NAMZ wiring harnesses are made in the USA, everyday, in our Pennsylvania building!
Features & Benefits:-* Waterproof Hot Melt Adhesive.* Shrink Temperature +605C.* Solder Melt Temp 138 DegC.* 16 to 14 AWG Wire Range.* Sold as a Pack (10)
Features & Benefits:-* Waterproof Hot Melt Adhesive.* Shrink Temperature +605C.* Solder Melt Temp 138 DegC* 12 to 10 AWG Wire Range.* Sold as a Pack (10)
Features & Benefit:-* 3/8in. Inside Diameter. * Sold as a 25ft Roll.* 2:1 Ratio
* Simply plug in between rear fender harness. * Add power to your Tour-Pak with quick-disconnect convenience* Connector is exposed behind the seat for easy removal.
Tech Tips:-* The two additional wires (white, Black) on the TBW unit are for heated grips. * An extension kit is offered for this # NMZ-NHGX-HD18* Simple installation, requires a basic terminal crimp tool. * Due to the connectors the factory uses, NAMZ were unable to make these extensions in.Plug-n-Playin..
Tech Tips:-* The two additional wires (white, Black) on the TBW unit are for heated grips. * An extension kit is offered for this # NMZ-NHGX-HD18* Simple installation, requires a basic terminal crimp tool. * Due to the connectors the factory uses, NAMZ were unable to make these extensions in.Plug-n-Playin..
Tech Tips:-* The two additional wires (white, Black) on the TBW unit are for heated grips. * An extension kit is offered for this # NMZ-NHGX-HD18* Simple installation, requires a basic terminal crimp tool. * Due to the connectors the factory uses, NAMZ were unable to make these extensions in.Plug-n-Playin..
Showing 49–64 of 123 results
No products in the cart.