Showing 81–96 of 222 results
-
$634.00
Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The two items must be heated prior to pulling the race or removing the nut with the sprocket wrench.Replacement Bearing Puller Plate = JM-34902-84-3
-
$675.00
* Use on all Twin Cam, Dyna 2006 & Big Twin 2007-2017.* Used to remove inner cam bearing without damaging the crankcase* Tool is also designed to keep rollers from falling into the crankcase* Instructions included* Made in the U.S.A.
-
$453.00
Features & Benefits:-* Fits Twin Cam Softail 2000-2006, Dyna 1999-2005 & Touring 1999-2006.* Used to remove inner cam bearing without damaging the crankcase.* Tool is also designed to keep rollers from falling into the crankcase.* Includes Instructions.Tech Tips:-* Will Not Fit Dyna 2006.Proudly Made in the USA by JIMS !
-
$679.00
The M8â„¢ engine returns to the single camshaft design, which requires a new tool for correct and accurate replacement of the camshaft inner needle bearing. Compared to the OEM tool, this remover uses the proven in.JIMS® stylein. remover collet as well as JIMS® fine threaded installation driver. We’ve incorporated a new removal hole that works…
-
$513.00
Features & Benefits:-* Installs the two cam needle bearings on Twin Cam 88 motors -perfectly aligns the shaft bore for a precise press fit.* Also installs the two inner cam bearings on Twin Cam Models 2007-2017 – aligns with the bore for a perfect installation, setting bearing depth at .023 to .028. * Bolts to…
-
-
-
$85.00
Features & Benefits:-* Allows proper disassembley & assembley of the Beta Engine Balancer* Holds Hydraulic Tensioners in place
-
$78.00
* Checks pinion and cam gears for pitch diameters* Sold in a sets of 2* Single cam engines only, includes S&S and aftermarket* Use on all Big Twin 1990-1999 single cam only. * Made in the U.S.A.NOTE: Includes aftermarket motors. See H-D service manual for sizing charts.
-
$78.00
* Checks pinion and cam gears for pitch diameters* Sold in a sets of 2* Complete sizing chart is included with the .105 gauge pins* Use on all Big Twin 1954-89.* Made in the U.S.A.
-
-
-
$337.00
* Installs lower leg 49mm fork seals squarely into the bore without damaging the seal lip surface* Also installs dust shield cover* Two-piece design to aid in some assembly applications* Made in the U.S.A.
-
$197.00
* Used to install fork and dust seals* Sold each* Made in the U.S.A.
-
$197.00
* Used to install fork and dust seals* Chrome cap installer is to be used in conjunction with PART #DS-197022 to install the OEM chrome fork slider covers on 39mm fork legs* Sold each* Made in the U.S.A.
-
Showing 81–96 of 222 results