Showing 49–64 of 222 results
-
$562.00
When changing valve springs for performance upgrades, or simply replacing a leaking valve seal, it is necessary for the technician to completely remove the cylinder head from the engine. This adds unnecessary time and expense. JIMS has developed a creative new tool that eliminates this step completely. This patent pending in.on bikein. valve spring compressor…
-
$50.00
* Works with all Perform filters manufactured after 2005* Works with all genuine Harley-Davidson filters * Will not work with any S&S filters* Wil not clear the crank position sensor on Softail 2000up
-
-
$647.00
Use to Remove & Install the main drive gear.Also installs the main bearing without removing transmission casethis tool will NOT damage bearing or main drive gear during install.Tech Tip:-* Will Not Fit Dyna 2006.
-
-
$468.00
The M8™ engine uses a completely unique engine case main bearing. With this in mind, JIMS is proud to introduce a main bearing remover and installer designed just for the M8™. High levels of precision and accuracy are necessary, so only the best in tools can be trusted. Our tool not only removes the left…
-
-
$634.00
Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The two items must be heated prior to pulling the race or removing the nut with the sprocket wrench.Replacement Bearing Puller Plate = JM-34902-84-3
-
$675.00
* Use on all Twin Cam, Dyna 2006 & Big Twin 2007-2017.* Used to remove inner cam bearing without damaging the crankcase* Tool is also designed to keep rollers from falling into the crankcase* Instructions included* Made in the U.S.A.
-
$453.00
Features & Benefits:-* Fits Twin Cam Softail 2000-2006, Dyna 1999-2005 & Touring 1999-2006.* Used to remove inner cam bearing without damaging the crankcase.* Tool is also designed to keep rollers from falling into the crankcase.* Includes Instructions.Tech Tips:-* Will Not Fit Dyna 2006.Proudly Made in the USA by JIMS !
-
$679.00
The M8™ engine returns to the single camshaft design, which requires a new tool for correct and accurate replacement of the camshaft inner needle bearing. Compared to the OEM tool, this remover uses the proven in.JIMS® stylein. remover collet as well as JIMS® fine threaded installation driver. WeÂ’ve incorporated a new removal hole that works…
-
$513.00
Features & Benefits:-* Installs the two cam needle bearings on Twin Cam 88 motors -perfectly aligns the shaft bore for a precise press fit.* Also installs the two inner cam bearings on Twin Cam Models 2007-2017 – aligns with the bore for a perfect installation, setting bearing depth at .023 to .028. * Bolts to…
-
-
-
$85.00
Features & Benefits:-* Allows proper disassembley & assembley of the Beta Engine Balancer* Holds Hydraulic Tensioners in place
-
$78.00
* Checks pinion and cam gears for pitch diameters* Sold in a sets of 2* Single cam engines only, includes S&S and aftermarket* Use on all Big Twin 1990-1999 single cam only. * Made in the U.S.A.NOTE: Includes aftermarket motors. See H-D service manual for sizing charts.
Showing 49–64 of 222 results